欧美人与禽交片免播放

<pre id="tnsiz"><nobr id="tnsiz"></nobr></pre>
  • <code id="tnsiz"><small id="tnsiz"><samp id="tnsiz"></samp></small></code>
  • <center id="tnsiz"><small id="tnsiz"></small></center>

          1. Home > Engineering Station > Engineering Station
            TURBINE ENGINEER
            The breakdown of the steam turbine is one of five major severe accidents referring to power outage across the plant, large-area power cuts, main equipment damage, fire and personal death and injury. Once the turbine is damaged, it will take a long time to repair and recover the power supply. The way of effective prevention or minimization of equipment damage is largely determined by the following factors: equipment maintenance and repair techniques, operational skills, and diagnosing and handling abilities of workers toward the accident. Workers are expected to discover and solve the problem timely and effectively. In fact, there are signs before most accidents. If those signs are discovered and handled in time, the accident will be prevented or at least the loss will be greatly reduced. On the contrary, if those signs are ignored owing to the lack of operational analysis of workers, severe equipment damage will be inevitable.
            Please Ask Questions From Engineers( You may ask questions in Bahasa Indonesia.)
            Hot Topic
            / 2017-12-19
            Boiler feed water pum0
            Why boiler feed water pump side outboard high temperature?
            It is common for the pump body to overheat the pump body because of the friction caused by the bearing damage, or because of the lack of oil and oil in the lubricating system. Therefore, after finding that the pump body is overheating, check whether the lubricating system is lacking in oil or lubricating oil containing impurities, and then check whether the bearing is damaged. It is necessary to check whether the rolling bearing or bracket cover is too small for the overheating of the newly overhauled pump body. Pump body after pass the inspection still fever should check whether the pump shaft is bent or two different axis center, at the same time to check the impeller balance, adjustment pump shaft or two shaft concentricity, remove the impeller balance hole, to ensure the pump shaft and the impeller rotation balance, troubleshooting.
            / 2017-11-17
            Electrical
            See the bottom pic!! My plant capacity is 15 MW and I have maintaining always negative reactive power.Is there any problem if I maintain negative reactive power always???
            Hello, sir. Negative reactive power can not allow to run in the longer time. Please adjust power factor, control it to around 80. If still have questions, please leave your name with email address and mobile number. I will contact you right away, and if needed, send our technician to help solve your problems.
            / 2016-10-05
            Describe the procedure of scraping the steel pad of bush?
            In the bush depression nest coat with a thin layer of red lead, under the three steel pad thereon grinding coloring the colored marks be repaired using a fine rasp or scraper blade, after three steel pad contacts simultaneously qualified, and then make the pad on the lower part steel pad thickness reduce 0.05 ~ 0.07mm, it can achieve scraping requirements. Note that identify colored marks, smear red lead oil too much is likely to cause the illusion.
            1234567...113
            Write Your Comments
            100% customer satisfaction is our service philosophy, and to further improve our service quality and understand client satisfaction toward our engineer, we have establish a comment system where our clients can make an evaluations for the engineers that serve them.
            Grade
            29-17-2017
            By
            Q ingin belajar
            Grade
            29-17-2017
            By
            Q sangat suka
            Grade
            07-16-2016
            By Dodi
            Really awesome?
            123